Product Features
 Fully compliant with JEDEC e·MMC 5.1 Standard (JESD84-B51)
 100-ball BGA, 1.0mm pitch
 14 x 18mm, RoHS compliant
 3D TLC NAND base technology in Enhanced Mode (pSLC)
 Industrial Operating Temperature -40 to 85°C
 Single enhanced mode partition
 High performance e·MMC 5.1 specification
o Eleven-wire bus (clock, Data Strobe, 1 bit command, 8 bit data bus) and a hardware reset
o Three different data bus width modes: 1-bit (default), 4-bit, and 8-bit
o Clock frequencies 0-200MHz, High Speed Mode HS400
o Command Queue Feature according to e·MMC Spec 5.1
o Up to 300MB/s sequential read and up to 230MB/s sequential write
 Power Supply: (Low-power CMOS technology)
o VCCQ 1.7V…1.95V or 2.7V…3.6V e·MMC supply
o VCC 2.7V…3.6V NAND Flash supply
 Optimized FW algorithms
o Power-fail data loss protection
o Wear Leveling technology
Equal wear leveling of static and dynamic data. The wear leveling assures that dynamic data
as well as static data is balanced evenly across the memory. With that the maximum write
endurance of the device is ensured
o Read Disturb Management
The read commands per region are monitored and the content is conditionally refreshed
when critical levels have occurred
o Auto Read Refresh
The interruptible background process maintains the user data for Read Disturb effects or
Retention degradation due to high temperature effects
o Diagnostic features with Device Health Report according to e·MMC Spec 5.1, and detailed
Lifetime Monitor data (Swissbit proprietary, accessible through standard e·MMC commands).
o Field Firmware update3 according to e·MMC Spec 5.1
o Discard and Sanitize, Trim
o Boot Operation Mode and Alternative Boot Operation Mode
o Replay Protected Memory Block (RPMB)
 High reliability
o Designed with sophisticated firmware architecture for industrial and embedded markets.
o Enhanced Mode (pSLC) with higher write performance and endurance than 3D TLC configured
products (EM-30).
o Ideal for application like POS/POI, PLC, IoT, gaming, medical and use as general boot medium for
embedded applications.
o The product is optimized for long life cycle that requires superior data retention as well as
power fail safety.
o Controlled BOM & PCN process