Function and Pinout Compatible With FCT
and F Logic
25-Ω Output Series Resistors to Reduce
Transmission-Line Reflection Noise
Reduced VOH (Typically = 3.3 V) Version of
Equivalent FCT Functions
Edge-Rate Control Circuitry for
Significantly Improved Noise
Characteristics
Ioff Supports Partial-Power-Down Mode
Operation
Matched Rise and Fall Times
Fully Compatible With TTL Input and
Output Logic Levels
ESD Protection Exceeds JESD 22
– 2000-V Human-Body Model (A114-A)
– 200-V Machine Model (A115-A)
– 1000-V Charged-Device Model (C101)
3-State Outputs
12-mA Output Sink Current
15-mA Output Source Current
Edge-Triggered D-Type Inputs
250-MHz Typical Switching Rate

description
The CY74FCT2574T is a high-speed, low-power, octal D-type flip-flop featuring separate D-type inputs for each
flip-flop. On-chip termination resistors at the outputs reduce system noise caused by reflections. The
CY74FCT2574T can replace the CY74FCT574T to reduce noise in an existing design. This device has 3-state
outputs for bus-oriented applications. A buffered clock (CP) and output-enable (OE) inputs are common to all
flip-flops. The CY74FCT2574T is identical to the CY74FCT2374T, except that on the CY74FCT2574T all
outputs are on one side of the package and all inputs are on the other side. The flip-flops in the CY74FCT2574T
store the state of their individual D inputs that meet the setup-time and hold-time requirements on the low-to-high
CP transition. When OE is low, the contents of the flip-flops are available at the outputs. When OE is high, the
outputs are in the high-impedance state. The state of OE does not affect the state of the flip-flops.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs,
preventing damaging current backflow through the device when it is powered down.