Features
 Highly-integrated memory controller
o SATA Rev 2.6 - 3Gbit/s (1.5Gbit/s compatible)
o max. UDMA6 MDMA2, PIO4, supported
o Hardware BCH-code ECC
(24bit correction per double sector or
6bit per sector)
o Fix drive configuration
 Small form factor:
o CompactFlash card sized Solid State Drive (SSD)
with SATA interface
o 42.8mm x 36.4mm x 3.3mm (max. 3.6mm)
 7+17 pin (SATA+power) CFast connector
 3.3V ± 5% power supply
 Very low Power, typical 250mA in transfer operation (CFAST Power level 0)
 CFast PHYSLP supported (<20 mA)
 Activity and SATAlink LED output at LED1 and LED2 pin
 write protect at connector IO1 pin
 Special features
o S.M.A.R.T. support with additional vendor information,
interpretation with Swissbit life time monitoring tool
o TRIM command
o NCQ queue depth 32
o HPA (Host protected area)
o Security mode feature set
o LBA48 command set
o host initiated power management requests
o write protection with vendor command
 Wear Leveling: active wear leveling of static and dynamic data
The wear leveling assures that dynamic data as well as static data is balanced evenly across the
memory. With that the maximum write endurance of the device is guaranteed.
 Read disturb management (refresh data when flash often read)
 High reliability
o Best available SLC NAND Flash technology
o Designed for embedded market
o MTBF > 2,500,000 hours
o Data reliability: < 1 non-recoverable error per 1014 bits read
o Number of connector insertions/removals: >10,000
 High performance
o Up to 300MB/s burst transfer rate in SATA II - 3.0Gb/sec
o Sustained Write performance: up to 100MB/s (4channel)
o Sustained Read Performance: up to 130MB/s (4channel)
 Available densities
o 2GByte up to 64GByte (SLC NAND Flash)
 2 Temperature ranges
o Commercial Temperature range 0 … +70°C
o Industrial Temperature range -40 … +85°C
 Life Cycle Management
 Controlled BOM
 RoHS compatible