поискавой системы для электроныых деталей
  Russian  ▼
ALLDATASHEETRU.COM

X  

  • MH41FBG-R

  • AI
    The **MH41FBG-R** is a specific type of Hall Effect sensor, typically categorized as a high-sensitivity, bipolar latching Hall effect IC. These components are widely used in automotive, industrial, and consumer electronics for position sensing and speed detection. --- ### 1. Technical Specifications Below are the primary technical characteristics of the MH41FBG-R: | Parameter | Specification | | :--- | :--- | | **Sensor Type** | Hall Effect (Bipolar Latch) | | **Supply Voltage (Vcc)** | 3.0V to 24V | | **Output Current** | 25mA to 50mA (typical) | | **Magnetic Sensitivity** | High (Bop: 50G / Brp: -50G approx.) | | **Package Type** | SOT-23 (Surface Mount) | | **Operating Temperature** | -40°C to +125°C | --- ### 2. Key Internal Components The "Electronic Parts" within this IC consist of several integrated stages: 1. **Hall Element:** A thin layer of semiconductor material that generates a small voltage (Hall Voltage) when exposed to a magnetic field. 2. **Voltage Regulator:** Allows the chip to operate across a wide range of input voltages (3V–24V) while maintaining internal stability. 3. **Chopper-Stabilized Amplifier:** Amplifies the tiny Hall voltage while canceling out offset errors and temperature drift. 4. **Schmitt Trigger:** Provides hysteresis to prevent "chattering" or noise at the switching point. 5. **Open-Collector Output:** An NPN transistor that acts as a switch. It requires an external pull-up resistor to function correctly. --- ### 3. Pin Configuration (SOT-23) The device typically features three pins: * **Pin 1 (VCC):** Power supply input. * **Pin 2 (OUT):** The output signal (switches to GND when a magnetic field is detected). * **Pin 3 (GND):** Ground connection. --- ### 4. Typical Applications * **Brushless DC (BLDC) Motors:** Used for commutation to detect rotor position. * **Speed Sensing:** Measuring the RPM of fans, wheels, or gears. * **Magnetic Encoding:** Detecting the rotation of shafts in industrial machinery. * **Proximity Switching:** Non-contact lid or door closure sensors. --- ### 5. Implementation Example To use this part in a digital circuit (like with an Arduino), a **10kΩ pull-up resistor** is required between the `OUT` pin and `VCC`. ```cpp // Basic Logic for Reading the Sensor int sensorPin = 2; // Connected to Pin 2 of MH41FBG-R int val = 0; void setup() { pinMode(sensorPin, INPUT); // Digital input Serial.begin(9600); } void loop() { val = digitalRead(sensorPin); if (val == LOW) { Serial.println("Magnetic South Pole Detected"); } else { Serial.println("Magnetic North Pole Detected / Idle"); } } ```
    ✨ Follow-up Questions
    • ⤷What is the difference between a bipolar latch and a unipolar Hall effect sensor?
    • ⤷ What is the recommended value for the pull-up resistor on the output pin?
    • ⤷ How does temperature affect the magnetic switching points of the MH41FBG-R?