AI

The **FG-R14-6B** is a specialized high-precision current sensor (transducer) primarily designed for detecting leakage currents in electric vehicle (EV) charging stations and industrial power electronics. It is manufactured by **KEMET** (a subsidiary of YAGEO).
---
## 1. Technical Overview
The FG-R14-6B is a **Residual Current Sensor (RCS)** that utilizes the Fluxgate principle. Unlike standard Transformers, Fluxgate sensors can detect both Alternating Current (AC) and Direct Current (DC) leakages, making them essential for modern power systems.
### Key Specifications
| Parameter | Value / Range |
| :--- | :--- |
| **Input Current Range** | 0 to ±300 mA (Leakage) |
| **Supply Voltage** | 12V DC (typical) |
| **Signal Output** | Analog (Proportional to leakage) |
| **Detection Type** | Type B (AC, DC, and Pulsating DC) |
| **Internal Hole Diameter** | 14 mm |
| **Operating Temperature** | -40°C to +105°C |
---
## 2. Core Components & Operation
The "Electronic Parts" within the sensor module consist of a sophisticated feedback loop.
### Internal Hardware Architecture
1. **Magnetic Core:** A high-permeability ring core through which the primary conductors (L1, L2, L3, and N) pass.
2. **Excitation Coil:** A winding that drives the core into saturation at a high frequency.
3. **Detection Circuitry:** ASICs (Application-Specific Integrated Circuits) that measure the symmetry of the saturation curves.
* If no leakage exists, the magnetic fields cancel out.
* If a leakage occurs, the DC or AC offset shifts the saturation point, which the electronics convert into a voltage signal.
4. **Oscillator:** Generates the excitation frequency for the fluxgate operation.
5. **Output Driver:** Buffers and scales the signal for the micro-controller of the charging station (EVSE).
---
## 3. Compliance and Standards
Because this part is used in safety-critical applications, it adheres to international safety standards for "Residual Current Monitoring Devices" (RCMDs):
* **IEC 62752:** In-cable control and protection devices for EV charging.
* **IEC 62955:** Specifically for Residual Direct Current Detection Devices (RDC-DD) for EV charging.
* **UL 2231:** Personnel protection systems for EV supply circuits.
---
## 4. Typical Integration (Pinout)
The sensor usually features a small pitch connector (e.g., JST) with the following typical pin functions:
* **VCC:** Power supply (usually 12V).
* **GND:** Reference ground.
* **Vout:** Analog output proportional to the detected residual current.
* **Test/Reset:** To trigger a self-diagnostic test of the sensor's functionality.
---
- ⤷
What is the difference between Type A and Type B residual current detection?
- ⤷ How does the Fluxgate principle differ from a standard Hall Effect sensor?
- ⤷ What are the common failure modes for the FG-R14-6B in EV charging applications?