ET-1010-R
AI

The **ET-1010-R** is a high-performance **Industrial Ethernet-to-Fiber Media Converter**. It is designed to bridge copper-based Ethernet networks (RJ45) with fiber optic networks, typically used in harsh industrial environments for long-distance data transmission.
---
## 1. Key Electronic Components and Ports
The device consists of several critical electronic interfaces and internal circuitry designed for reliability:
| Component | Specification/Function |
| :--- | :--- |
| **Ethernet Port** | 1 x 10/100 Base-TX RJ45 Port (Auto MDI/MDI-X). |
| **Fiber Port** | 1 x 100 Base-FX (Multi-mode or Single-mode depending on variant). |
| **Connector Type** | Usually **ST** or **SC** connectors (The "-R" often denotes specific fiber range/type). |
| **Internal Controller** | Specialized ASIC for Store-and-Forward or Cut-Through switching. |
| **Power Input** | Redundant terminal block (usually 12-48V DC). |
---
## 2. Technical Electronic Features
### Signal Conversion
The core electronics convert the **Electrical Differential Signaling** of a standard CAT5/6 cable into **Optical Signals** (light pulses). This allows data to travel up to 2km (Multi-mode) or 30km+ (Single-mode) without electromagnetic interference (EMI).
### Protection Circuitry
Because it is "Industrial Grade," the ET-1010-R includes:
* **ESD Protection:** Usually 6kV contact discharge protection.
* **EFT Protection:** 2kV protection on power lines.
* **Reverse Polarity Protection:** Prevents damage if the DC power wires are swapped.
### Diagnostic LEDs
The PCB is equipped with several LED indicators to monitor the status of the electronics:
* **PWR:** Power status.
* **Link/Act:** Activity on the Ethernet or Fiber side.
* **FDX/Col:** Full Duplex or Collision detection.
---
## 3. Physical Construction
* **Casing:** IP-30 rated metal housing which acts as a heat sink (fanless design).
* **Mounting:** DIN-rail or wall mount brackets.
* **Operating Temperature:** Typically rated for **-10°C to 60°C**, though wide-temp versions can reach -40°C to 75°C.
---
## 4. Usage Context
In a typical circuit, the ET-1010-R acts as a transparent bridge. You connect a PLC or Industrial PC to the RJ45 port, and the electronics encapsulate that data for transmission over the fiber backbone to a central control room.
- ⤷
What is the maximum fiber distance supported by the ET-1010-R?
- ⤷ Does this model support Link Fault Pass-Through (LFP)?
- ⤷ What are the specific power requirements for the terminal block?