| поискавой системы для электроныых деталей |
|
INTEDG датащи(PDF) 367 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
INTEDG датащи(HTML) 367 Page - Microchip Technology |
|
367 / 478 page ![]() 2010-2012 Microchip Technology Inc. DS41414D-page 367 PIC16(L)F1946/47 27.14 Configuring the LCD Module The following is the sequence of steps to configure the LCD module. 1. Select the frame clock prescale using bits LP<3:0> of the LCDPS register. 2. Configure the appropriate pins to function as segment drivers using the LCDSEn registers. 3. Configure the LCD module for the following using the LCDCON register: - Multiplex and Bias mode, bits LMUX<1:0> - Timing source, bits CS<1:0> - Sleep mode, bit SLPEN 4. Write initial values to pixel data registers, LCDDATA0 through LCDDATA23. 5. Clear LCD Interrupt Flag, LCDIF bit of the PIR2 register and if desired, enable the interrupt by setting bit LCDIE of the PIE2 register. 6. Configure bias voltages by setting the LCDRL, LCDREF and the associated ANSELx registers as needed. 7. Enable the LCD module by setting bit LCDEN of the LCDCON register. 27.15 Disabling the LCD Module To disable the LCD module, write all ‘0’s to the LCDCON register. 27.16 LCD Current Consumption When using the LCD module the current consumption consists of the following three factors: • Oscillator Selection • LCD Bias Source • Capacitance of the LCD segments The current consumption of just the LCD module can be considered negligible compared to these other factors. 27.16.1 OSCILLATOR SELECTION The current consumed by the clock source selected must be considered when using the LCD module. See Section 30.0 “Electrical Specifications” for oscillator current consumption information. 27.16.2 LCD BIAS SOURCE The LCD bias source, internal or external, can contrib- ute significantly to the current consumption. Use the highest possible resistor values while maintaining contrast to minimize current. 27.16.3 CAPACITANCE OF THE LCD SEGMENTS The LCD segments which can be modeled as capaci- tors which must be both charged and discharged every frame. The size of the LCD segment and its technology determines the segment’s capacitance. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |