| поискавой системы для электроныых деталей |
|
PIC12F1822-I/MF датащи(PDF) 193 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
PIC12F1822-I/MF датащи(HTML) 193 Page - Microchip Technology |
|
193 / 398 page ![]() 2010 Microchip Technology Inc. Preliminary DS41413A-page 193 PIC12F/LF1822/16F/LF1823 22.5 CARRIER SOURCE POLARITY SELECT The signal provided from any selected input source for the carrier high and carrier low signals can be inverted. Inverting the signal for the carrier high source is enabled by setting the MDCHPOL bit of the MDCARH register. Inverting the signal for the carrier low source is enabled by setting the MDCLPOL bit of the MDCARL register. 22.6 CARRIER SOURCE PIN DISABLE Some peripherals assert control over their correspond- ing output pin when they are enabled. For example, when the CCP1 module is enabled, the output of CCP1 is connected to the CCP1 pin. This default connection to a pin can be disabled by set- ting the MDCHODIS bit in the MDCARH register for the carrier high source and the MDCLODIS bit in the MDCARL register for the carrier low source. 22.7 PROGRAMMABLE MODULATOR DATA The MDBIT of the MDCON register can be selected as the source for the modulator signal. This gives the user the ability to program the value used for modulation. 22.8 MODULATOR SOURCE PIN DISABLE The modulator source default connection to a pin can be disabled by setting the MDMSODIS bit in the MDSRC register. 22.9 MODULATED OUTPUT POLARITY The modulated output signal provided on the MDOUT pin can also be inverted. Inverting the modulated out- put signal is enabled by setting the MDOPOL bit of the MDCON register. 22.10 SLEW RATE CONTROL The slew rate limitation on the output port pin can be disabled. The slew rate limitation can be removed by clearing the MDSLR bit in the MDCON register. 22.11 OPERATION IN SLEEP MODE The DSM module is not affected by Sleep mode. The DSM can still operate during Sleep, if the Carrier and Modulator input sources are also still operable during Sleep. 22.12 Effects of a Reset Upon any device Reset, the Data Signal Modulator module is disabled. The user’s firmware is responsible for initializing the module before enabling the output. The registers are reset to their default values. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |