PIC12F1822-ISLASHMF datasheet(208/398 Pages) MICROCHIP

208 / 398 page

PIC12F/LF1822/16F/LF1823

DS41413A-page 208

Preliminary

 2010 Microchip Technology Inc.

23.4

PWM (Enhanced Mode)

The enhanced PWM mode generates a Pulse-Width

Modulation (PWM) signal on up to four different output

pins with up to 10 bits of resolution. The period, duty

cycle, and resolution are controlled by the following

registers:

• PR2 registers

• T2CON registers

• CCPR1L registers

• CCP1CON registers

The ECCP modules have the following additional PWM

registers which control Auto-shutdown, Auto-restart,

Dead-band Delay and PWM Steering modes:

• CCP1AS registers

• PSTR1CON registers

• PWM1CON registers

The enhanced PWM module can generate the following

four PWM Output modes:

• Single PWM

• Half-Bridge PWM

• Full-Bridge PWM (PIC16F/LF1823 only)

• Single PWM with PWM Steering Mode

To select an Enhanced PWM Output mode, the P1M bits

of the CCP1CON register must be configured

appropriately.

The PWM outputs are multiplexed with I/O pins and are

designated P1A, P1B, P1C and P1D. The polarity of the

PWM pins is configurable and is selected by setting the

bits

CCP1M<3:0>

the

CCP1CON

appropriately.

Figure 23-5 shows an example of a simplified block

diagram of the Enhanced PWM module.

Table 23-8 shows the pin assignments for various

Enhanced PWM modes.

FIGURE 23-5:

EXAMPLE SIMPLIFIED BLOCK DIAGRAM OF THE ENHANCED PWM MODE

Note 1: The corresponding TRIS bit must be

cleared to enable the PWM output on the

CCP1 pin.

2: Clearing the CCP1CON register will

relinquish control of the CCP1 pin.

3: Any pin not used in the enhanced PWM

mode is available for alternate pin

functions, if applicable.

4: To

prevent

the

generation

incomplete waveform when the PWM is

first enabled, the ECCP module waits

until the start of a new PWM period before

generating a PWM signal.

CCPR1L

CCPR1H (Slave)

Comparator

TMR2

Comparator

PR2

(1)

Duty Cycle Registers

DC1B<1:0>

Clear Timer,

toggle PWM pin and

latch duty cycle

Note 1:

The 8-bit timer TMR1 register is concatenated with the 2-bit internal Q clock, or 2 bits of the prescaler to create the 10-bit time

base.

PIC16F/LF1823 only.

TRISx

CCP1/P1A

TRISx

P1B

TRISx

P1C(2)

TRISx

P1D(2)

Output

Controller

P1M<1:0>

CCP1M<3:0>

PWM1CON

CCP1/P1A

P1B

P1C(2)

P1D(2)

PIC12F1822-I/MF датащи(PDF) 208 Page - Microchip Technology

PIC12F1822-I/MF датащи(HTML) 208 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL