ATmega128 datasheet(210/386 Pages) ATMEL

210 / 386 page

210

2467S–AVR–07/09

ATmega128

application must load a data packet into TWDR. Subsequently, a specific value must be

written to TWCR, instructing the TWI hardware to transmit the data packet present in

TWDR. Which value to write is described later on. However, it is important that the

TWINT bit is set in the value written. Writing a one to TWINT clears the flag. The TWI will

not start any operation as long as the TWINT bit in TWCR is set. Immediately after the

application has cleared TWINT, the TWI will initiate transmission of the data packet.

When the data packet has been transmitted, the TWINT flag in TWCR is set, and TWSR

is updated with a status code indicating that the data packet has successfully been sent.

The status code will also reflect whether a slave acknowledged the packet or not.

The application software should now examine the value of TWSR, to make sure that the

data packet was successfully transmitted, and that the value of the ACK bit was as

expected. If TWSR indicates otherwise, the application software might take some special

action, like calling an error routine. Assuming that the status code is as expected, the

application must write a specific value to TWCR, instructing the TWI hardware to transmit

a STOP condition. Which value to write is described later on. However, it is important that

the TWINT bit is set in the value written. Writing a one to TWINT clears the flag. The TWI

will not start any operation as long as the TWINT bit in TWCR is set. Immediately after

the application has cleared TWINT, the TWI will initiate transmission of the STOP condi-

tion. Note that TWINT is NOT set after a STOP condition has been sent.

ATmega128 датащи(PDF) 210 Page - ATMEL Corporation