ATmega128 datasheet(163/386 Pages) ATMEL

номер детали	ATmega128

подробное описание детали	8-bit Microcontroller with 128K Bytes In-System Programmable Flash

PDF	386 Pages

Scroll/Zoom	100%

производитель	ATMEL [ATMEL Corporation]

домашняя страница	http://www.atmel.com

Logo

163 / 386 page

163

2467S–AVR–07/09

ATmega128

Serial

Peripheral

Interface – SPI

The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer between the

ATmega128 and peripheral devices or between several AVR devices. The ATmega128 SPI

includes the following features:

• Full-duplex, Three-wire Synchronous Data Transfer

• Master or Slave Operation

• LSB First or MSB First Data Transfer

• Seven Programmable Bit Rates

• End of Transmission Interrupt Flag

• Write Collision Flag Protection

• Wake-up from Idle Mode

• Double Speed (CK/2) Master SPI Mode

Figure 75. SPI Block Diagram

Note:

Refer to Figure 1 on page 2 and Table 30 on page 74 for SPI pin placement.

The interconnection between Master and Slave CPUs with SPI is shown in Figure 76. The sys-

tem consists of two Shift Registers, and a Master clock generator. The SPI Master initiates the

communication cycle when pulling low the Slave Select SS pin of the desired Slave. Master and

Slave prepare the data to be sent in their respective Shift Registers, and the Master generates

the required clock pulses on the SCK line to interchange data. Data is always shifted from Mas-

ter to Slave on the Master Out – Slave In, MOSI, line, and from Slave to Master on the Master In

– Slave Out, MISO, line. After each data packet, the Master will synchronize the Slave by pulling

high the Slave Select, SS, line.

DIVIDER

/2/4/8/16/32/64/128

ATmega128 датащи(PDF) 163 Page - ATMEL Corporation