ATmega16 datasheet(136/357 Pages) ATMEL

136 / 357 page

136

2466S–AVR–05/09

ATmega16(L)

byte to the SPI Data Register starts the SPI clock generator, and the hardware shifts the eight

bits into the Slave. After shifting one byte, the SPI clock generator stops, setting the end of

Transmission Flag (SPIF). If the SPI Interrupt Enable bit (SPIE) in the SPCR Register is set, an

interrupt is requested. The Master may continue to shift the next byte by writing it into SPDR, or

signal the end of packet by pulling high the Slave Select, SS line. The last incoming byte will be

kept in the Buffer Register for later use.

When configured as a Slave, the SPI interface will remain sleeping with MISO tri-stated as long

as the SS pin is driven high. In this state, software may update the contents of the SPI Data

until the SS pin is driven low. As one byte has been completely shifted, the end of Transmission

Flag, SPIF is set. If the SPI Interrupt Enable bit, SPIE, in the SPCR Register is set, an interrupt

is requested. The Slave may continue to place new data to be sent into SPDR before reading

the incoming data. The last incoming byte will be kept in the Buffer Register for later use.

Figure 66. SPI Master-Slave Interconnection

The system is single buffered in the transmit direction and double buffered in the receive direc-

tion. This means that bytes to be transmitted cannot be written to the SPI Data Register before

the entire shift cycle is completed. When receiving data, however, a received character must be

read from the SPI Data Register before the next character has been completely shifted in. Oth-

erwise, the first byte is lost.

In SPI Slave mode, the control logic will sample the incoming signal of the SCK pin. To ensure

correct sampling of the clock signal, the minimum low and high periods should be:

Low periods: Longer than 2 CPU clock cycles.

High periods: Longer than 2 CPU clock cycles.

When the SPI is enabled, the data direction of the MOSI, MISO, SCK, and SS pins is overridden

according to Table 55 on page 136. For more details on automatic port overrides, refer to “Alter-

nate Port Functions” on page 55.

Table 55. SPI Pin Overrides

Direction, Master SPI

Direction, Slave SPI

MOSI

User Defined

Input

MISO

Input

User Defined

SCK

User Defined

Input

User Defined

Input

MSB

MASTER

LSB

8 BIT SHIFT REGISTER

MSB

SLAVE

LSB

8 BIT SHIFT REGISTER

MISO

MOSI

SPI

CLOCK GENERATOR

SCK

MISO

MOSI

SCK

SHIFT

ENABLE

ATmega16 датащи(PDF) 136 Page - ATMEL Corporation

ATmega16 датащи(HTML) 136 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL