AT89C5132-ROTIL datasheet(149/182 Pages) ATMEL

149 / 182 page

149

4173E–USB–09/07

AT89C5132

version (see Section "End Of Conversion", page 149). This bit is cleared by hardware at the end

of the conversion.

Notes:

1. Only the CPU activity is frozen, peripherals are not affected by the Pseudo-Idle mode.

2. If some interrupts occur during the Pseudo-Idle mode, they will be delayed and processed,

according to their priority after the end of the conversion.

3. Concurrently with ADSST bit.

21.1.4

Configuration

The ADC configuration consists in programming the ADC clock as detailed in the Section "Clock

Generator", page 148. The ADC is enabled using the ADEN bit in ADCON register. As shown in

Figure 93, user must wait the setup time (TSETUP) before launching any conversion.

Figure 21-4. ADC Configuration Flow

21.1.5

Conversion Launching

The conversion is launched by setting the ADSST bit in ADCON register, this bit remains set

during the conversion. As soon as the conversion is started, it takes 11 clock periods (TCONV)

before the data is available in ADDH and ADDL registers.

Figure 21-5. ADC Conversion Launching Flow

21.1.6

End Of Conversion

The end of conversion is signalled by the ADEOC flag in ADCON register becoming set or by the

ADSST bit in ADCON register becoming cleared. ADEOC flag can generate an interrupt if

ADC

Configuration

Enable ADC

ADIDL = x

ADEN = 1

Wait Setup Time

Program ADC Clock

ADCD4:0 = xxxxxb

ADC

Conversion Start

Select Channel

ADCS = 0-1

Start Conversion

ADSST = 1

AT89C5132-ROTIL датащи(PDF) 149 Page - ATMEL Corporation