ST92141 datasheet(149/179 Pages) STMICROELECTRONICS

149 / 179 page

149/179

ST92141 - ANALOG TO DIGITAL CONVERTER (ADC)

ANALOG TO DIGITAL CONVERTER (Cont’d)

On devices where two A/D Converters are present

they can be triggered from the same source.

7.6.2.3 Analog Watchdogs

Two internal Analog Watchdogs are available for

highly flexible automatic threshold monitoring of

external analog signal levels.

Analog channels 6 and 7 monitor an acceptable

voltage level window for the converted analog in-

puts. The external voltages applied to inputs 6 and

7 are considered normal while they remain below

their respective Upper thresholds, and above or at

their respective Lower thresholds.

When the external signal voltage level is greater

than, or equal to, the upper programmed voltage

limit, or when it is less than the lower programmed

voltage limit, a maskable interrupt request is gen-

erated and the Compare Results Register is up-

dated in order to flag the threshold (Upper or Low-

er) and channel (6 or 7) responsible for the inter-

rupt. The four threshold voltages are user pro-

grammable in dedicated registers (08h to 0Bh) of

the ADC register page. Only the 4 MSBs of the

Compare Results Register are used as flags, each

of the four MSBs being associated with a threshold

condition.

Following a reset, these flags are reset. During

normal ADC operation, the CRR bits are set, in or-

der to flag an out of range condition and are auto-

matically reset by hardware after a software reset

of the Analog Watchdog Request flag in the ICR

7.6.2.4 Power Down Mode

Before enabling an A/D conversion, the POW bit of

the Control Logic Register must be set; this must

be done at least 60µs before the first conversion

start, in order to correctly bias the analog section

of the converter circuitry.

When the ADC is not required, the POW bit may

be reset in order to reduce the total power con-

sumption. This is the reset configuration, and this

state is also selected automatically when the ST9

is placed in Halt Mode (following the execution of

the halt instruction).

Figure 79. A/D Trigger Source

Converter

External Trigger

On Chip Event

(Internal trigger)

A/D 0

EXTRG pin

MFT 0

A/D 1

Analog Voltage

Upper threshold

Lower threshold

Normal Area

(Window Guarded)

ST92141 датащи(PDF) 149 Page - STMicroelectronics

ST92141 датащи(HTML) 149 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL