ST10F272M datasheet(105/175 Pages) STMICROELECTRONICS

105 / 175 page

ST10F272M

Power reduction modes

105/176

Warning:

During power-off phase, it is important that the external

hardware maintains a stable ground level on RSTIN pin,

without any glitch, in order to avoid spurious exiting from

reset status with unstable power supply.

21.3.2

Exiting stand-by mode

After the system has entered the Stand-by mode, the procedure to exit this mode consists of

a standard Power-on sequence, with the only difference that the RAM is already powered

through V18SB internal reference (derived from VSTBY pin external voltage).

It is recommended to held the device under RESET (RSTIN pin forced low) until external

VDD voltage pin is stable. Even though, at the very beginning of the power-on phase, the

device is maintained under reset by the internal low voltage detector circuit (implemented

inside the main voltage regulator) till the internal V18 becomes higher than about 1.0V, there

is no guaranty that the device stays under reset status if RSTIN is at high level during

power ramp up. So, it is important the external hardware is able to guarantee a stable

ground level on RSTIN along the power-on phase, without any temporary glitch.

The external hardware is responsible for driving the RSTIN pin low until the VDD is stable,

even though the internal LVD is active.

Once the internal Reset signal goes low, the RAM (still frozen) power supply is switched to

the main V18.

At this time, everything becomes stable, and the execution of the initialization routines can

start: XRAM2EN bit can be set, enabling the RAM.

21.3.3

Real time clock and stand-by mode

When Stand-by mode is entered (turning off the main supply VDD), the Real Time Clock

counting can be maintained running in case the on-chip 32 kHz oscillator is used to provide

the reference to the counter. This is not possible if the main oscillator is used as reference

for the counter: Being the main oscillator powered by VDD, once this is switched off, the

oscillator is stopped.

21.3.4

Power reduction modes summary

The different Power reduction modes are summarized in the following Table 44.

Table 44.

Power reduction modes summary

Mode

Idle

off

run

off

biased

off

run

biased

ST10F272M датащи(PDF) 105 Page - STMicroelectronics

ST10F272M датащи(HTML) 105 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL