| поискавой системы для электроныых деталей |
|
STM32MP157F датащи(PDF) 230 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32MP157F датащи(HTML) 230 Page - STMicroelectronics |
|
230 / 260 page ![]() Electrical characteristics STM32MP157C/F 230/260 DS12505 Rev 5 Figure 56. DDR mode FDCAN (controller area network) interface Refer to Section 6.3.17: I/O port characteristics for more details on the input/output alternate function characteristics (FDCANx_TX and FDCANx_RX). USB OTG_FS characteristics The USB interface is fully compliant with the USB specification version 2.0 and is USB-IF certified (for Full-speed device operation). Note: When VBUS sensing feature is enabled, a typical 200 μA input current (required to determine the different sessions validity according to USB standard) can be observed. Ethernet (ETH) characteristics Unless otherwise specified, the parameters given in Table 107, Table 108, Table 109, Table 110 and Table 111 for MDIO/SMA, RMII, GMII, RGMII and MII are derived from tests performed under the ambient temperature, Faxiss_ck frequency summarized in Table 13: General operating conditions, with the following configuration: • Output speed is set to OSPEEDRy[1:0] = 10 • Capacitive load C = 20 pF • Measurement points are done at CMOS levels: 0.5×VDD. MSv63044V1 Data output D0 D2 D4 Clock Data input D0 D2 D4 t(CK) tw(CKH) tw(CKL) tr(CK) tf(CK) tsf(IN) thf(IN) tvf(OUT) thr(OUT) D1 D3 D5 D1 D3 D5 tvr(OUT) thf(OUT) tsr(IN) thr(IN) Table 106. USB OTG_FS electrical characteristics Symbol Parameter Condition Min Typ Max Unit VDD33USB USB transceiver operating voltage -3.0(1) -3.6 V RPUI Embedded USB_DP pull-up value during idle - 900 1250 1600 Ω RPUR Embedded USB_DP pull-up value during reception - 1400 2300 3200 ZDRV Output driver impedance(2) Driver high and low 28 36 44 1. The USB functionality is ensured down to 2.7 V but not the full USB electrical characteristics which are degraded in the 2.7 to 3.0 V voltage range. 2. No external termination series resistors are required on USB_DP (D+) and USB_DM (D-); the matching impedance is already included in the embedded driver. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |