AT89C5131A-RDTIM datasheet(131/184 Pages) ATMEL

131 / 184 page

131

AT89C5130A/31A-M

4337C–USB–02/05

Suspend/Resume Management

Suspend

The Suspend state can be detected by the USB controller if all the clocks are enabled

and if the USB controller is enabled. The bit SPINT is set by hardware when an idle

state is detected for more than 3 ms. This triggers a USB interrupt if enabled.

In order to reduce current consumption, the firmware can put the USB PAD in idle mode,

stop the clocks and put the C51 in Idle or Power-down mode. The Resume detection is

still active.

The USB PAD is put in idle mode when the firmware clear the SPINT bit. In order to

avoid a new suspend detection 3ms later, the firmware has to disable the USB clock

input using the SUSPCLK bit in the USBCON Register. The USB PAD automatically

exits of idle mode when a wake-up event is detected.

The stop of the 48 MHz clock from the PLL should be done in the following order:

Clear suspend interrupt bit in USBINT (required to allow the USB pads to enter

power down mode).

Enable USB resume interrupt.

Disable of the 48 MHz clock input of the USB controller by setting to 1 the SUS-

PCLK bit in the USBCON register.

Disable the PLL by clearing the PLLEN bit in the PLLCON register.

Make the CPU core enter power down mode by setting PDOWN bit in PCON.

Resume

When the USB controller is in Suspend state, the Resume detection is active even if all

the clocks are disabled and if the C51 is in Idle or Power-down mode. The WUPCPU bit

is set by hardware when a non-idle state occurs on the USB bus. This triggers an inter-

rupt if enabled. This interrupt wakes up the CPU from its Idle or Power-down state and

the interrupt function is then executed. The firmware will first enable the 48 MHz gener-

ation and then reset to 0 the SUSPCLK bit in the USBCON register if needed.

The firmware has to clear the SPINT bit in the USBINT register before any other USB

operation in order to wake up the USB controller from its Suspend mode.

The USB controller is then re-activated.

AT89C5131A-RDTIM датащи(PDF) 131 Page - ATMEL Corporation